Linux version 2.4.17 (root@localhost.localdomain) (gcc version 2.96 20000731 (Red Hat Linux 7.1 2.96-98)) #2 Wed Mar 20 08:18:06 EST 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009c000 (usable)
 BIOS-e820: 000000000009c000 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e7400 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000efe0000 (usable)
 BIOS-e820: 000000000efe0000 - 000000000efefc00 (ACPI data)
 BIOS-e820: 000000000efefc00 - 000000000eff0000 (ACPI NVS)
 BIOS-e820: 000000000eff0000 - 000000000f100000 (reserved)
 BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
On node 0 totalpages: 61408
zone(0): 4096 pages.
zone(1): 57312 pages.
zone(2): 0 pages.
Kernel command line: ro root=/dev/hda1
Initializing CPU#0
Detected 793.215 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1464.72 BogoMIPS
Memory: 239256k/245632k available (1042k kernel code, 5976k reserved, 284k data, 216k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0080893f 0081813f 0000000e, vendor = 7
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 512K (128 bytes/line)
CPU: Processor revision 1.4.1.0, 800 MHz
CPU: Code Morphing Software revision 4.2.6-8-168
CPU: 20010703 00:29 official release 4.2.6#2
CPU: After vendor init, caps: 0080893f 0081813f 0000000e 00000000
CPU:     After generic, caps: 0080893f 0081813f 0000000e 00000000
CPU:             Common caps: 0080893f 0081813f 0000000e 00000000
CPU: Transmeta(tm) Crusoe(tm) Processor TM5800 stepping 03
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: none
PCI: PCI BIOS revision 2.10 entry at 0xfd88e, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router ALI [10b9/1533] at 00:07.0
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.15)
Starting kswapd
VFS: Diskquotas version dquot_6.4.0 initialized
Journalled Block Device driver loaded
pty: 512 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
Real Time Clock Driver v1.10e
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller on PCI bus 00 dev 78
PCI: No IRQ known for interrupt pin A of device 00:0f.0. Please try using pci=biosirq.
ALI15X3: chipset revision 195
ALI15X3: not 100% native mode: will probe irqs later
hda: IBM-DJSA-220, ATA DISK drive
hdc: TOSHIBA DVD-ROM SD-R2102, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 39070080 sectors (20004 MB) w/1874KiB Cache, CHS=2432/255/63
ide-floppy driver 0.97.sv
Partition check:
 hda: hda1 hda2 hda3
floppy0: no floppy controllers found
ide-floppy driver 0.97.sv
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 321k freed
VFS: Mounted root (ext2 filesystem).
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 216k freed
Adding Swap: 522104k swap-space (priority -1)
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
PCI: Found IRQ 11 for device 00:02.0
usb-ohci.c: USB OHCI at membase 0xcf854000, IRQ 11
usb-ohci.c: usb-00:02.0, Acer Laboratories Inc. [ALi] M5237 USB
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
hub.c: USB new device connect on bus1/2, assigned device number 2
usb.c: USB device 2 (vend/prod 0x409/0x40) is not claimed by any active driver.
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi0 : SCSI emulation for USB Mass Storage devices
  Vendor: NEC       Model: USB UF000x        Rev: 1.21
  Type:   Direct-Access                      ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide0(3,1), internal journal
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide0(3,3), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
ip_conntrack (1919 buckets, 15352 max)
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
NET4: AppleTalk 0.18a for Linux NET4.0
8139too Fast Ethernet driver 0.9.22
PCI: Found IRQ 9 for device 00:12.0
eth0: RealTek RTL8139 Fast Ethernet at 0xcf89f800, 00:e0:00:85:68:f5, IRQ 9
eth0:  Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 41e1.
Linux Kernel Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
PCI: Found IRQ 9 for device 00:0c.0
Yenta IRQ list 04f8, PCI irq9
Socket status: 30000006
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x408-0x40f 0x480-0x48f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 2880 512-byte hdwr sectors (1 MB)
sda: Write Protect is off
 sda:
EXT2-fs warning: checktime reached, running e2fsck is recommended
usb-ohci.c: USB suspend: usb-00:02.0
usb-ohci.c: odd PCI resume for usb-00:02.0
8139too Fast Ethernet driver 0.9.22
PCI: Found IRQ 9 for device 00:12.0
eth0: RealTek RTL8139 Fast Ethernet at 0xcf89f800, 00:e0:00:85:68:f5, IRQ 9
eth0:  Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 41e1.
eth0: Too much work at interrupt, IntrStatus=0x0001.
eth0: Too much work at interrupt, IntrStatus=0x0001.